Page 1
360m 360r 360i MIRA 360m SHOWERHEAD MIRA 360r SHOWERHEAD MIRA 360i SHOWERHEAD INSTALLATION & USER GUIDE These instructions must be left with the user.
FLOW RATES INTRODUCTION The flow rates for the Mira 360 showerheads are Introduction listed below. Thank you for purchasing a quality Mira product. To enjoy the full potential of your new product, please take time to read this guide thoroughly, having...
OPERATION Turn the showerhead in the direction shown to activate the different spray patterns. Rain Cloud Burst Storm...
Page 4
Cleaning Spray Plate Assembly Many household cleaners contain abrasives and 1. Use a suitable tool to remove the grommets. chemical substances, and should not be used for 2. Using the 2.5 mm hexagonal wrench (supplied), cleaning plated or plastic fittings. remove the screws.
Page 5
4. Replace the Cloud assembly sprayplate with the LC version. 5. Reassemble the components in reverse order. Grommet Checkvalve (360m and 360r) - 1688.282 Seals Screws Seals Checkvalve (360i) - 1688.283 To comply with UK Water Regulations you must make provision to prevent the backflow of waste water through the shower.
SPARE PARTS Spare part numbers are indicated in bold and are available from authorised stockists or merchants (locations on request) or direct from Mira Customer Services, our contact details can be found on the back cover of this guide. 575.12 Hexagonal Wrench - 2.5 mm (not illustrated)
Fax: 01242 282595 of limescale, frost damage, corrosion, system debris or By Post: Mira Customer Services Dept, Cromwell Road, blocked fi lters) or where no fault has been found with Cheltenham, Gloucestershire, GL52 5EP the product.