Table of Contents
Advertisement
Installation
WARNING
Danger of fire and electric shock
■ When passing the cable through the hole, do not tear the shield
otherwise it may cause electric shock or breakdown of the sensor.
STEP 1
Affix the mounting template at the desired mounting position.
* Mounting height depends on the header sensor.
STEP 2
Drill two mounting holes of ø3.4mm (ø1/8").
To pass the cable through the header, drill a wiring hole of
STEP 3
ø12mm (ø1/2").
Remove the mounting template.
STEP 4
STEP 5
Fasten the screws aligning the mounting plate to the mounting holes.
STEP 6
Wiring the cable to the door controller.
WARNING
Danger of fire and electric shock
■ Before starting the procedure, make sure that the power is turned
OFF.
■ Do not use this product exceeding the power supply range.
■ When passing the cable through the hole, do not tear the shield.
Otherwise it may cause electric shock or breakdown of the sensor.
■ Do not extend, forcibly bend, pull off, twist, and bundle the cable.
STEP 7
Remove the housing cover.
STEP 8
Fix the header sensor to main body by a screw, and connect to the header sensor connector.
Fix with a screw.
Screw is attached
to the main body.
アプリパスワード
リセットスイッチ
5740120
Made in Japan
配 線
動作表示灯
青色グラデーション点滅：
ウォームアップ時
ビスポケット
青色点灯：
待機時
緑色グラデーション点滅：
無駄開きキャンセル時
赤色点灯：
検出時
速い紫色/青色交互点滅：
故障表示
1.
Mounting plate
Raise the knob on the left side of the
housing cover while holding the main body.
Fix the header sensor, aligning the lines.
遅い緑色/青色交互点滅：
アプリ接続中
速い緑色/青色交互点滅
→消灯：
アプリパスワードリセット
紫色点灯/青色2回点滅：
交換目安表示
(電源投入後5分間のみ)
WARNING
Danger of getting caught in the door
■ Do not use exceeding the mounting height of the specification.
■ Do not mount on the oblique surface.
Enlarged view
Mounting template
Door controller side
1. White
2. Brown
3. Green
4. Yellow
5. Pink (+)
6. Blue (-)
7. Red (+)
8. Black (-)
1.本製品を取付プレートの
2.取付プレートに押し当てながら
爪の上に載せます。
引き下げるようにして、
かん合部をはめます。
爪
- 3 -
爪
かん合部
2.
Power supply
Activation
output
Safety output
Safety input
IPアドレス
リセット表示灯
* Contact our local sales representative in case
IPアドレス
リセットスイッチ
of installing this product with OA-AXIS T,
OAM-DUAL series and X-ZONE series.
2.2 to 4.2m
24VDC
Form A relay
50V 0.1A max.
Opto coupler
Opto coupler
Advertisement
Table of Contents
