Optex VVS-1 Operation Manual page 4

Installation
STEP 9 Fix the main body to the mounting plate.
Put the main body on the hook of the mounting plate.
Hook
Confirm that the protruded parts of this product are fully lowered and fixed on the both sides of claws of the mounting plate.
STEP 10 Connect the wiring connector and the power/output connector.
WARNING
■ Make sure that the connectors are properly connected.
When detaching this product from the mounting plate, raise the sensor upward while pushing down the removing pawl as shown below.
Supply power to the sensor. After warm-up for approx. 30sec., this product becomes the stand-by state.
STEP 11
Adjust the image recognition area and set the dipswitches.
STEP 11 STEP 12
(Refer to Web setting manual.)
For the header sensor, refer to the operation manual of the header sensor.
For the dust proof, affix the attached protection seals to
STEP 13
the openings section of this product.
Hook
Fitting section
Danger of fire and electric shock
Raise it upward.
Perform fitting and pull down while pressing the main body to the mounting
plate.
Push down the removing pawl.
LAN
port
- 4 -
Dipswitches