Adaptec AHA-1510A Series User Manual page 53

Problem
The aspi2dos ASPI manager is installed. The system will not boot
from the SCSI hard disk drive, and the aspi2dos logo does not
appear on the screen.
Action
1
Make sure that aspi2dos.sys is in the root directory of the boot
drive.
2
Make sure that your config.sys file contains this line:
device=aspi2dos.sys /d
Additional command line options are required for AHA-1510A
host adapter boards. See the EZ-SCSI User's Manual for details.
Problem
General difficulties using a SCSI drive as drive D with a standard
hard disk as drive C.
Action
1
Make sure that hard disk 1 (D) is set to Not Installed or No
Drive Installed with your CMOS Setup program.
2
Make sure that the SCSI drive you want to use as drive D is set
to SCSI ID 0:0. Check your drive manual for information on
setting the SCSI ID for that device.
3
Make sure that SCSI parity is consistently enabled or disabled
on all devices on the SCSI bus.
4
Make sure that SCSI termination is set correctly on the host
adapter and the peripherals.
5
If your system is running under DOS, make sure that the disk
has a DOS partition and a DOS format.
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-1510A/20A Series User's Guide
A
A A
Stock Number: 510400-00, Rev. C
A A
A A Print Spec Number: 491842-00
A A
Current Date: 11/18/94
AAAA AAAA A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Page: 5-3
ECN Date: 11/29/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
Troubleshooting
5-3
A
A A
A A
A A
A
A A
A A
AAAA A A A A