Advertisement
BOOSTER FUNCTION:
The «Booster» can speed the rise of power of the induction burner.
It is controlled by positioning the lever on the landmark P. During
10 minutes, the maximum power of the burner is obtained.
P
The display shows the letter P.
After 10 minutes, the power is reset to level 9.
9
The display shows the number 9.
Note:
In case of simultaneous operation of dual induction burners, (Front / Rear),
the Booster function can only be achieved on only one of the selected
burners. The Booster function remains active on the last selected burner.
ACCELARATOR FUNCTION:
The Accelerator function allows to be on level 9 for 8 minutes then switch
automatically back to the level of the selected power.
To use the accelerator function: from the position 0, turn the knob on the
left (slight turn to the left).
A
The display shows the letter A.
Set the knob to the desired power level.
USER'S MANUAL
INDUCTION
P
A
INDUCTION
ACTIVATING THE CHILD SAFETY FUNCTION:
Single heater :
Replace the knobs to zero, turn the knob
of the burner anti-clockwise and hold in
L
this position until activation (2 seconds
approximately) This feature is symbolized by
an L display.
Double heater :
Turn the two right
control knobs anti-clockwise
and hold in this position for a couple
L
of seconds to activate of child security
function (signalled by the letter L). The
child safety function is now active for
the two right induction rings. If the
control knobs for the two right zones
are now turned, nothing will happen.
DESACTIVATE CHILD SAFETY:
Single heater :
Repeating the process described above to a zone
wich has been made safe, will re-activate the
zone and the letter L will go out.
Double heaters :
To
desactivate
safety, turn the two handles
of both burners in the anti-
clockwise and hold it until
the deactivation of the child
safety function.
The letter L will go out.
OVER HEATING CUT OUT:
In case of overheating, the system will trip and render the burner innoperative.
In that case:
•
Reset the controller of the burner in question to 0.
•
Remove the pan from burner.
•
Wait for the burner to cool before re-use.
23
induction
the
child
USER'S MANUAL
EN
10-2016
Advertisement
