Troubleshooting - Taurus Alpatec COLD DESIGN Manual

Problems
The air conditioning does
not work.
The cooling effect is not
good
Big Noise
compressor does not
work.
The remote control does
not work.
Displays 'E1'.
Displays 'E2'
Reasons
There is no electricity.
The overflow indicator will light
on/flash.
The ambient temperature is too
low or too high
In cooling mode, the room
temperature is lower than the set
temperature; in heating mode, the
room temperature is higher than
the set temperature.
In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
mode, there are other sources of
heat.
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed
on a flat surface.
Frost production starts.
Overheat protection starts.
The distance between the
machine and the remote control
is too far.
The remote control is not aligned
with the direction of the remote
control receiver.
Batteries are dead.
The room temperature sensor
failure.
The pipe temperature sensor
failure.
Solutions
Turn it on after connecting it to a
socket with electricity.
Discharge the water inside.
Recommend to use the machine
in at the temperature of 7-35 °C
(44-95 °F).
Change the set temperature.
The machine is placed in a room
with an ambient temperature of
greater than 17 °C (62 °F).
Pull the Curtain.
Close doors and windows, and
add new air conditioning.
Clean or replace the filter
screen.
Clear obstructions.
Put the air conditioning on a
flat and hard place (to reduce
noise).
Wait for 3 minutes until the
temperature is lowered, and
then restart the machine.
Let the remote control get close
to the air conditioning, and make
sure that the remote control
directly faces to the direction of
the remote control receiver.
Replace batteries.
Check the room temperature
sensor and related circuitry.
Check the pipe temperature
sensor and related circuitry.