ActionTec UP101 User Manual page 21

Actiontec Internet Phone Wizard User Manual
7. Insert the other end of the supplied phone cable in a standard phone line out-
let. The components should be connected similarly to the figure below:
☞
Note: If the Internet Phone Wizard needs to be disconnected from
the computer for any reason, it must be reconnected to the same
port. Connecting the Internet Phone Wizard to a different
USB
port may cause problems.
USB
The Internet Phone Wizard is connected in Dual Line mode. Next, go to chapter 4,
"Installing the Internet Phone Wizard Software."
Dual Line Connection with DSL Modem
Since modems are connected via phone line (like the Internet Phone Wizard),
DSL
there are two ways to connect the Internet Phone Wizard when a
ent: Connecting to a Phone Line Splitter, and Connecting to a
configuration matching the current computer/
Connecting to a Phone Line Splitter
If the telephone is connected to the phone line via a phone line splitter, follow
this procedure to connect the Internet Phone Wizard:
1. Get the Internet Phone Wizard from its package.
2. Get the
cable from the package and insert the small, square end of the
USB
cable in the "
USB
3. Insert the other (flat and rectangular) end of the
the front or back of a computer.
4. Use the supplied phone cable and insert it in the "Line" port of the Internet
Phone Wizard.
" port on the rear panel of the Phone Wizard.
set up, and follow the instructions.
DSL
USB
18
modem is pres-
DSL
Filter. Select the
DSL
cable in a port on
USB