Days EQUALIZER SYSTEMS EQ Smart-Level Installation/Operation/Warranty Manual page 20

Helpful Hints
Do not allow motion in the coach during the Auto Level operation (don't move around in the
•
coach). This could cause the system to fault out or level/stabilize improperly.
• The Auto-Level is a microprocessor-controlled system. Proper and adequate battery voltage and
permanent chassis ground are essential.
• Your system is equipped with override ability. Refer to the procedure for proper use of this.
It is usually better to review this procedure prior to its actual use, rather than having to learn a
new procedure in difficult environments and or situations. This is designed to get the jacks
retracted if there has been a power/control failure.
• If the system has not been used (with the jacks stowed) for over 24 hours, it is recommended
that you engage the All Retract button prior to travel in order to re-pressurize the system.
• A lubricant, like WD40, may be used to clean and lubricate the cylinder shafts.
Manual Operation
Push and release the Power Keypad button to engage power. All lights will come on then most will
go out. The LED light next to the Power button should be lit RED when power is on. You will need to
have the ignition key switch in the off position to extend the jacks. If you attempt to extend jacks by
pressing the Down Keypad buttons or all the jacks with the Auto-Level button, you will hear a "deny"
tone from the keypad if the ignition key is in the improper position. Also depending on if the park
brake disable is connected and the park brake is released you may not be able to extend jacks. (See
step 9 on page 5).
Using the Down Keypad buttons, extend the jacks until they contact the ground (this is referred to as
"planting" the jacks). As you extend the jacks, an LED light on the Keypad will indicate the jack(s) is
out of the "stowed" position. Jacks may only be operated in pairs using the manual keypad buttons.
Use a bubble level on a flat surface in the center of the coach. Level the vehicle by using the Down
or Up Keypad buttons until the vehicle is level. Jacks may be operated only in pairs. Press the power
button to turn off the control panel (Keypad).
To retract push and release the Power Keypad button to engage power. Press the all Retract button
to retract the jacks prior to travel. This system does provide the ability to retract the jacks using the
UP buttons for each pair of jacks. However, these buttons are not intended to be used for retracting
the jacks to their stowed position prior to travel. The Up arrows are to be used only for retracting the
jacks to help level the coach. The All Retract button must be pressed to ensure the system is ready/
safe for travel. All jacks should automatically retract and return to stowed position when the ALL
RETRACT button is pressed and released. The pump will run in retract for approximately 5 seconds
after the last jack has been fully retracted- or until a time limit of 90 seconds has been reached.
Check/test the following: If you have properly installed the ignition disable circuit, the jacks will not
extend if the ignition key is in the on (engine run position). And the ignition on LED should come on.
When you turn the key off the LED should go out and allow extension. This is a required connection/
step. Failure to properly connect this could create an unsafe condition and may void the warranty.
20