Days EQUALIZER SYSTEMS EQ Smart-Level Installation/Operation/Warranty Manual page 18

Step 2 - Setting the Null
Null is the term used to indicate the levelness of the coach. A Null setting should have been
performed by the installer. If the coach is not level following an attempt to Auto Level, you will need to
level the coach and reset the null.
Use a bubble level on a flat surface in the center of the coach as a reference. You do not need to
have the jacks deployed to set the null.
To set the null, first press the POWER button on the keypad to activate the unit. The LED light
•
next to the Power button should be lit RED when the power is on.
• Level the coach by deploying jacks manually, or by simply parking the coach on a level site. Once
the coach is level, turn the POWER off at the panel.
• While holding down the AUTO LEVEL button, press and release the POWER button. This should
cause the keypad to make a series of beeps.
• After the Keypad has beeped 5 to 6 times, release the AUTO LEVEL button and you will get a
confirmation beep. (The Keypad will continue to beep if the Auto Level button is held) The new null
has been set and the panel will store/remember this setting.
• Press and release the ALL RETRACT button to retract the jacks to the stowed position.
Note: if you are not clear on this process please check our website for videos and/or call
Equalizer Systems for assistance.
18