Advertisement
Available languages
Available languages
TEST MEASUREMENTS:
FITNESS.
This electronic device is equipped with a
recovery test function. This offers you
the advantage of being able to measure
how long it takes your heart rate to
recover
after
exercise. After finishing the exercise
leave your hands on the pulse sensors
(R) and press the "Fitness Test" button
and this will start a one minute
countdown. Only the Time and Pulse
rate function read-outs will remain
displayed. The electronic device will
measure your pulse rate during this
minute. The heart rate recovery time will
be displayed on the Heart rate line. If, at
any time during this minute, you decide
to abandon this test then press the
"Test" button and this will take you back
to the main screen. When the minute is
up, the electronic device will work out
the difference and your fitness rating will
be displayed up on the screen: "F1,
F2,..., F5, F16; where F1 is the best
(fitness "Excellent") and F6 the worst
(fitness "Very Poor").
Pressing the TEST button will take you
back to the main screen, where the
functions will be in the same mode as
when the TEST began.
Your fitness rating is a guideline that
shows you how fast your heart recovers
after physical exertion. If you exercise
regularly then you will see your fitness
rating improve.
The TEST will not work if you do not
have both hands placed on the hand-
grip sensors (R) Fig3 after you have
stopped doing the exercise.
If the error code "E1" is shown on the
screen then this means that you do not
have your hands positioned correctly on
the hand-grip sensors (R).
If the error code "E2" appears on the
having
finished
screen, this means that you have not
stopped exercising.
FITTING THE ELECTRONIC
MONITOR.-
Bring the monitor (1) to the handlebar
stem (4) Fig.7, connect the two
the
terminals (19/49) coming out of the
handlebar stem (4) and the monitor (1)
Fig.5.
Insert
the
handlebar stem (4), as shown in Fig.5,
making sure not to pinch any of the
cables. Fit the bolts (3) along with the
flat washers, securely tighten.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function Works.
Solution:
a.-Make sure that the connection
cable is connected.
Problem: The monitor does not switch
on.
Solution:
a.-
Check
connections.
b.-Check the cable connections for the
main post.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
13
monitor
(1)
onto
the
monitor
the
cable
Advertisement
