Crestron ZUMMESH-JBOX Series Quick Start Manual page 4

ZUMMESH-JBOX Series
Zūm™ Mesh Wireless J-Box Load Controllers
ZUMMESH-JBOX-16A-LV-EM Wiring
IMPORTANT SAFEGUARDS:
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Do not mount near gas or electric heaters.
l
Equipment should be mounted in locations and at heights where it
l
will not be subjected to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the
l
manufacturer may cause an unsafe condition.
Do not use this equipment for other than its intended use.
l
SAVE THESE INSTRUCTIONS
WARNING: The installation and the use of this product within a
specific installation must be approved by an applicable local, state, or
federal Authority Having Jurisdiction (AHJ). All installations must be
performed by qualified personnel according to applicable local and
regional codes and standards. Requirements vary between
jurisdictions.
NOTES:
When wiring a ZUMMESH-JBOX-16A-LV-EM, ensure that power is
l
routed through a transfer switch for emergency load control.
After normal power is lost, 200 ms (120 V) or 750 ms (277 V) must
l
pass before the ZUMMESH-JBOX-16A-LV-EM is powered by an
emergency power source.
Quick Start
4