Diagnostic Outputs - Emerson E Series Installation Manual

Diagnostic Outputs

The diagnostic outputs are located on the front of the drive allow you to
measure drive parameters. There are two diagnostic output channels
associated with these test points.
Default assignments:
Output 1 = Velocity Feedback
± 10V = -± 6000 RPM
Output 2 = Torque Command
± 10V =. ± 300% of continuous motor torque
Figure 38
Diagnostic Output Test Points
Diagnostic
Output #1
Diagnostic
Output GND
Diagnostic
Output #2
* * e s * * * * * * \
Troubleshooting
61