Acnodes PANEL PC 1000 Installation Manual page 2

PANEL PC 1000 INSTALLATION GUIDE
HDD
The standard PANEL PC 1000 already builds in a 2.5" hard disk drive.
To remove the existing device for repair or for a higher-capacity one, follow the installation instructions below.
1. Take out the screws and remove the HDD bracket. Mounting orientation of the HDD brackets on PANEL PC 1000 are not similar.
The four screws mounting the PANEL PC 1000 HDD bracket sits at the bottom of the bracket.
2. Reinstall the new hard disk drive to the HDD bracket and screw the HDD bracket to the system compartment again. The four rubber
stands act as cushions to lessen the vibration that usually causes damage to mechanical devices like a hard disk driv
NOTE:
Mounting screws of the PANEL PC 1000 HDD are installed from the both sides of the HDD bracket
III. I/O OUTLETS
The following figure shows the I/O arrangement of the PANEL PC1000. The backside of the chassis contains most of the
connectors.
1. Ethernet RJ-45 phone jack
2. PS/2 mouse
3. Keyboard
4. External FDD
5. 4-channel Digital Inputs/outputs
6. Parallel port
7. COM4
NOTE:
Default settingm for RS-232 type Touch-Screen on COM3
ACNODE.COM
INFO@ACNODES.COM
8. COM3
9. COM2
10. COM1
11. VGA port IF
12. AC inlet
13. Power switch
14. +5V/12V DC outlet
er.