Getting Started; Unpacking The System; Back View; Using The Antenna - RCA RS2035 User Manual

RS2035 EN 2/12/04 10:06 AM

Getting Started

Unpacking the system

You should have the following:
• one main unit (with 2 main speakers);
• one remote control;
• one user's guide;
• one safety leaflet;
• Owner registration card

Back View

2
1
1. FM Pigtail Antenna
2. Main Speaker Jacks

Using the Antenna

Before you use your audio system, you'll want to
make sure the FM antenna is positioned properly.
The FM antenna is the coiled wire connected to
the back of the unit. Uncoil it, making sure it is
fully extended (you may even want to tape it to
the wall behind the unit, if possible. The higher,
the better.)
For better AM reception, move or rotate the unit.

Connecting the Speakers

RS2035 - Match the blue wire (on the left
speaker) to blue terminal for the left speaker (L)
on the back of the unit and the black wire (on
the left speaker ) to the black terminal for left
speaker (L). Follow the same procedure to
connect the right (R) speaker.
Page 7
RS2035RD - Match the red wire (on the left
speaker) to red terminal for the left speaker (L)
on the back of the unit and the black wire (on
the left speaker ) to the black terminal for left
speaker (L). Follow the same procedure to
connect the right (R) speaker.
Speaker Wire Connection
Push Speaker terminal tab
down to insert wire.
NOTE: Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.

Installation

To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
Front View
4 inches
Side View
2 inches
Release tab to lock wire in
the terminal.
4 inches
4 inches
ON•ECO
4 inches
EN
2