Digital Board Block-1 - Sony STR-ZA5000ES Service Manual

Multi channel av receiver
Hide thumbs Also See for STR-ZA5000ES:
Table of Contents

Advertisement

2-7.

DIGITAL BOARD BLOCK-1

• Continued on 2-8 (page 14).
Note 1: Please correctly connected the CN2100 (9 pin), CN2101 (6 pin), CN2103 (6 pin)
and CN8004 (9 pin) connectors as shown in the description below. When connected
to other connector wrong, there is a possibility that this unit may be damaged.
CN2102
cable tie
rear side
CN2101
CN2100
w; ANALOG board
qk Cut the cable tie.
(See Note 3)
wa ANALOG board
cable connector
(CN2101)
qj ANALOG board
cable connector
(CN2103)
qh ANALOG board
cable connector
(CN2102)
7 DCDC board
cable connector
(CN1507)
6 Remove the wire
from the clamp.
CN1507
clamp
rear side
8 flexible flat cable (FFC 11P (160)) (CN6000)
Note 2: Prevent the removed cable from
touching grease of heat sink.
Note 3: During reassembly, use new cable
ties to fasten the wires back in place
as they were before disassembly.
CN8004
CN2103
flexible flat cable
(FFC 9P (130))
(CN8006)
clamp
DIGITAL board
ql AMP board cable
cable connector
connector (CN8004)
(CN2100)
qa CIS board cable
connector (CN8010)
0 HUB board cable
connector (CN1509)
9 Remove the wire
from the clamp.
(See Fig. A)
1 Remove the wire
from the clamp.
Wind two times
of wires around
the clamp.
flexible flat cable
(FFC 11P (130))
(CN8011)
CN1509
CN8005
CN8010
CN8001
rear side
DIGITAL board
qg flexible flat cable (FFC 9P (130)) (CN8006)
qf flexible flat cable (FFC 11P (130)) (CN8011)
Note 2: Prevent the removed cable from touching
qd STBY board cable
connector (CN8001)
4 Remove the wire
from the clamp.
2 fan motor cable connector
(CN9001)
CN9001
STR-ZA5000ES
flexible flat cable
(FFC 11P (160))
CN1502
(CN6000)
cable tie
cable tie
cable tie
bracket
(Fix to the bracket (CNT).)
(CNT)
Note 2: Prevent the removed cable from touching
grease of heat sink.
grease of heat sink.
qs SPTM board cable
connector (CN8005)
5 DCDC board
cable connector
(CN1502)
3 Cut the cable tie.
(See Fig. B)
(See Note 3)
3 Cut the cable tie.
(See Fig. B)
(See Note 3)
3 Cut the cable tie.
(See Fig. B)
(See Note 3)
DC fan
rear side
rear side
DIGITAL
board
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents