Sony KDS-70Q006 Service Manual page 247

Problem
Cannot receive or select
channels
Some digital cable channels are
not being displayed
General
Problem
How to reset TV to factory
settings
How to restore Video settings
to factory settings
How to restore Audio settings
to factory settings
Cannot cycle through the other
video equipment connected to
the SXRD projection TV
Cannot operate Menu
Lost password
TIMER LED on front panel is
lit
POWER/STANDBY LED
blinks in red
LAMP LED blinks in red
The replacement lamp does not
light up
Digital cable box does not work
Cannot record digital channels
to VCR
Possible Remedies
❏
Auto Program
Use in the Channel menu to add receivable channels that are not
presently in SXRD projection TV memory (see page 116).
❏
Certain cable companies have limitations on the broadcast of digital cable
channels. Check with your cable company for more information.
❏
The digital cable channel may be set to
page 117).
Possible Remedies
❏
Turn on the TV. While holding down the
POWER
press the button on the TV. (The TV will turn itself off, then back on
RESET
again.) Release the
❏
Press RESET on the remote control while in the Video menu (see page 108).
❏
Press RESET on the remote control while in the Audio menu (see page 112).
❏
Be sure the Label Video Inputs
❏
If a menu option appears in gray, this indicates that the menu option is not
available.
❏
In the password screen (see page 118), enter the following master password:
4357. The master password clears your previous password; it cannot be used to
temporarily unblock channels.
❏
The i.LINK STANDBY LED blinks in red when the signal from an i.LINK device
is being shown.
❏
The LED (see page 26 or 137) blinks when the TV is turned on, then shuts off
when the picture is displayed. If the red LED blinks continuously, this may
indicate the TV needs service. When lit, indicates that the timer is set (see page 26
or 137). When the timer is set, this LED will remain lit even when the TV is
turned off.
❏
If the LED blinks three times, the lamp cover may not be attached securely (see
page 23).
❏
Replace the lamp (see page 20).
❏
The screw of the lamp cover may be slanted. Take out the screw, insert it straight
into the screw hole, and then tighten it completely (see page 20).
❏
If you are connecting a VCR and digital cable box using a splitter, as described on
page 42, you must use a special bi-directional splitter that is designed to work
with your digital cable box. Contact your cable provider for details.
❏
Only analog channels can be recorded to your VCR.
Hidden in the Digital Setup menu (see
RESET button on the remote control,
button.
option is not set to Skip
Other Information
(see page 123).
(Continued)
135