Sony KDS-70Q006 Service Manual page 118

On contamination on the screen surface
The screen surface has a special coating to reduce
reflections. To prevent screen damage, clean the screen as
follows:
❑
Clean the screen with a soft cloth, such as the
supplied cleaning cloth or a glass cleaning cloth.
❑
To remove hard contamination, use the supplied
cleaning cloth or a glass cleaning cloth moistened
with a solution of mild detergent and water.
❑
Do not use any type of abrasive pad, alkaline
cleaner, acid cleaner, scouring powder, chemical
cloth, or solvent such as alcohol, benzene or thinner,
as these may scratch the screen's coating.
Installation
Water and Moisture
Do not use power-line operated sets
near water — for example, near a
bathtub, washbowl, kitchen sink, or
laundry tub, in a wet basement, or
near a swimming pool, etc.
Accessories
Do not place the set on an unstable
cart, stand, table or shelf. The set may
fall, causing serious injury to a child or
an adult and serious damage to the set.
Use only a cart or stand recommended
by the manufacturer for the specific
model of SXRD projection TV. An appliance and cart
combination should be moved with care. Quick stops,
excessive force, and uneven surfaces may cause the
appliance and cart combination to overturn.
Ventilation
The slots and openings in the cabinet and in the back or
bottom are provided for necessary ventilation. To ensure
reliable operation of the set, and to protect it from
overheating, these slots and openings must never be
blocked or covered.
❑
Never cover the slots and openings
with a cloth or other materials.
❑
Never block the slots and openings
by placing the set on a bed, sofa, rug
or other similar surface.
6
❑
Never place the set in a confined
space, such as a bookcase or built-in
cabinet, unless proper ventilation is
provided.
❑
Do not place the set near or over a
radiator or heat register, or where it is
exposed to direct sunlight.
❑
Leave some space around the unit.
When installing the unit against a wall,
keep it at least 4 inches (10 cm) away from the wall.
Otherwise, adequate air circulation may be blocked,
causing overheating that may result in fire or
damage to the unit.
4 inches
(10 cm)
Never install the unit as follows:
Air circulation is blocked.
Power-Cord Protection
Do not allow anything to rest on or roll
over the power cord, and do not place the
set where the power cord is subject to
wear or abuse.
Antennas
Outdoor Antenna Grounding
If an outdoor antenna is installed, follow the precautions
below. An outdoor antenna system should not be located
in the vicinity of overhead power lines or other electric
light or power circuits, or where it can come in contact
with such power lines or circuits.
11 / inches (30 cm)
7
8
4 inches
(10 cm)
Allow this
much
space.
POWER
STD/DUO
less than
4 inches
(10 cm)