U)Sim Design Requirements - Fibocom NL668-LA Hardware User Manual

AT command (U)SIM card hot plug detection
AT+MSMPD=1 Enabled
AT+MSMPD=0 Disabled
After enabled the hot plug detection function of the (U)SIM card, if USIM_PRESENCE is in high level, the
module will detect the (U)SIM card insertion and execute card initialization program. After reading the
(U)SIM card information, the module will register network. When the USIM_PRESENCE is in low
the module detects (U)SIM card is removed, and it will not read the (U)SIM card.
Note:
The USIM_PRESENCE pin active high by default, and can be switched to active low by AT
command.
AT command
AT+GTSET=" SIMPHASE",1
AT+GTSET=" SIMPHASE",0

5.3.4 (U)SIM design requirements

(U)SIM card circuit design shall meet EMC standards and ESD requirements, and at the same time, shall
improve anti-interference ability to ensure that the (U)SIM card can work stably. The design needs to
strictly observe the following rules:
⚫
(U)SIM card connector is placed as close to the module as possible, away from the RF antenna,
DCDC power, clock signal lines and other strong interference sources;
⚫
Adopt the (U)SIM card connector with metal shield shell to improve anti-interference ability;
⚫
The length of cable from the module to the (U)SIM card connector shall not exceed 100mm. Longer
cable reduces signal quality.
⚫
USIM_CLK and USIM_DATA signals are ground isolated to avoid mutual interference. If it is difficult
to do so, (U)SIM signal needs to be ground protected as a set;
Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
FIBOCOM NL668-LA Series Hardware User Manual
Table 5- 7 (U)SIM Card Hot Plug Function Configured
Table 5- 8 USIM_PRESENCE
Function description
(U)SIM card hot plug detection is enabled by
default.
The module determines the insertion and
removal of (U)SIM card by detect the USIM_
PRESENCE pin state
(U)SIM card hot plug detection function is
disabled
The module read the (U)SIM card when module
power on, and does not detect the
USIM_PRESENCE state
Function description
Default, high level detect
Low level detect
Effective Level Switched
level,
Page 36 of 65