Table of Contents
Advertisement
Power off mode
Low-voltage power
off
Hardware power off
AT power off
Note:
1. When module at operating mode, please do not cut off module power supply to avoid
damage internal flash. Recommended by PWRKEY pin or AT commands power off module,
then cut off power supply.
2. When power off by AT commands, please don't pull down PWRKEY pin, otherwise module
will power on again automatically.
The power off timing is shown as follows:
5.1.2 RESET
The module supports two
Reset mode
Hardware reset
Software reset
Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
FIBOCOM NL668-LA Series Hardware User Manual
Power off methods
When VBAT voltage is low or power
down, the module will power off
Pull down PWRKEY 3s~8s
AT+ CPWROFF
Table 5- 2 Power off
Figure 5- 4 Power off Timing
modes
to reset: hardware reset and software reset.
Reset method
Pull down RESET_N pin 700s~1s, then release it
Sent AT commands AT+RESET
Table 5- 3 Reset
Applicable scenarios
The module does not power off through
normal process, i.e. does not logout from
the base station
Hardware normal power off
Software normal power off
Page 30 of 65
Advertisement
Table of Contents
