Page 2
TEMP TIME DOWN DOWN TEMP CANCEL TIME RESERVE TIMER CODE DOWN MODE RESERVE CANCEL UNIT N TIMER SWING MODE TEST TEST SWING TEST /TEST Figure 1 Figure 2 Figure 3 CODE UNIT N Figure 4 Figure 5...
Improper installation work may result in leakage, electric shock or fire hazards. Thank you for purchasing this Daikin remote controller. Carefully read this operation manual before using the air conditioner. It will tell you how...
Names and functions of the See figure 3, (receiver on decoration panel) operating section 17 EMERGENCY OPERATION SWITCH This switch is readily used if the remote controller does not work. See figure 1, (figure 1B shows the remote controller with front cover opened) 18 RECEIVER This receives the signals from the remote controller.
Handling for wireless remote Placing the remote controller in the remote controller holder controller Choose a place where the signals reach the unit. Install the remote controller holder to a wall or a pillar with the Precautions in handling remote controller attached screw.
Operation range ON/OFF Refer to the operation manual provided with the indoor unit Press ON/OFF button. or with the outdoor unit. The OPERATION lamp lights up or goes off and the If the indoor temperature or humidity is beyond operating system starts or stops operation.
Adjustment Press the AIR FLOW DIRECTION ADJUST button to select the air direction as shown below. For programming TEMPERATURE, FAN SPEED and AIR Display appears and the air flow direction FLOW DIRECTION, follow the procedure shown below. continuously varies. (Automatic swing setting.) TEMPERATURE SETTING Press AIR FLOW DIRECTION ADJUST Press TEMPERATURE SETTING button and program the...
Program timer operation Emergency operation Operate in the following order. When the remote controller does not work due to battery failure or the absence thereof, use the switch which is located The timer is operated in the following two ways: beside the discharge grille on the indoor unit.
Troubleshooting In case besides emergency stop 1 The unit does not operate at all. Emergency stop Check if the receiver is exposed of sunlight or strong (See figure 2) light. Keep receiver away from light. When the air conditioner stops unexpectedly, the ...
When you think there is Symptom 3: No changeover is available between HEATING and COOLING modes something wrong Example Reason The following symptoms do not indicate air conditioner The indoor unit makes a When operation changeover malfunction: long beep sound. is under control, the control is set to the mode that Symptom 1: The system does not operate...
Page 11
The two-dimensional bar code is a manufacturing code. 3P444561-1 M15B278 (1606) HT...