Napoleon TriVista NEFB50H-3SV Installation And Operation Manual page 31

symptom
No difference from Hard wire connections are not
Ember bed is Brightness not selected.
H1 to H2. correct.
not glowing or
Ember LED issue.
dimming.
Main PCB board issue.
Main PCB board issue.
Heating element issue.
LED flashing Appliance has overheated
Error code "E1". Thermostat issue.
"OH". and safety thermal switch has
symptom
tripped.
No difference from Hard wire connections are not
H1 to H2. correct.
Main PCB board issue.
Heating element issue.
Error code "E1". Thermostat issue.
problem
See "hard-wiring installation" section.
See "operation" section.
Inspect the ember bed LEDs and replace, if necessary.
Consult your dealer.
Inspect the main PCB board and replace, if necessary.
Consult your dealer.
Unplug power or turn off the circuit breaker. Allow appliance
Consult your dealer.
to cool for 15 minutes, then plug in the appliance or turn the
problem
breaker on. If problem persists, consults your dealer.
See "hard-wiring installation" section.
Consult your dealer.
Consult your dealer.
Consult your dealer.
troubleshooting
solution
solution
W415-1953 / C / 03.04.21
EN
31