Section 4. Remove The Pentair Control Panel; Transformer Located On Low Voltage Side - Jandy AquaLink RS Conversion Kit Installation Instructions Manual

Installation & Operation Manual
Section 4. Remove the Pentair
Before beginning the installation, verify the location has adequate WiFi coverage or
a wired Ethernet connection to the home router. The AquaLink RS Conversion Kit
uses a connection to the Internet. If Internet access is questionable or not functional,
it is advised to not proceed with the Pentair control panel removal and changes until a
access is ensured.
NOTE Use of this AquaLink
integrated Saltwater systems is not recommended. Refer to the
compatibility section 3 of this manual before proceeding.
TIP: For faster AquaLink
relay and valve connector, as you remove it, with the relay number, name, and function.
Risk of electric shock which can result in serious injury or
death: Before attempting to install or service, ensure that all power to
the circuit supplying power to the system is disconnected or turned off
at the circuit breaker. All wiring must be done in accordance with the
National Electrical Code
In Canada, the Canadian Electrical Code (CEC), CSA C22.1, must be followed. All
applicable local installation codes and regulations must be followed.
4.1 Transformer located in control panel compartment
1. Turn off power at the breaker panel.
2. Remove 2 retaining screws on top of the High Voltage cover panel,
see Figure 2(a).
Figure 2. Remove Dead Front Screws
3. Remove the High Voltage cover panel from enclosure.
4. Remove power to transformer from either the relay or resettable fuses.
RS Conversion Kit with Pentair
®
RS set up and programming, use tape and a marker to tag each
®
WARNING
(NEC) , NFPA-7
® ®
a
Control Panel
®
®
.
®
Page 11