Kruger DT 154 User Manual page 25

ACCESS TO THE DTI 200 FILTERS (
REMOVE THE FRONT GRILLE
Turn anti-clockwise the two support screws displayed in the photo.
DISASSEMBLE THE FRONT PANEL FRAME
Unscrew the 4 nuts at the 4 corners in the cleaning panel frame and remove the frame preventing it from falling
down.
REMOVE THE METALLIC PRE-FILTER
Disconnect the yellow-green cable of the earth connection from the metallic pre-filter as well as the red
connector placed on the grey cover of the electronic card. Unscrew the 2 fixing screws, push the two protru-
ding tongues of the pre-filter inwards and take the pre-filter out from the opposite side.
(WARNING: reassemble the red connector in the original position without any forcing).
REMOVE THE ELECTROSTATIC FILTER
1
Pull both hooks inwards (1-2), and let the filter fall catching it by the 2 blue handles
REASSEMBLING: Perform the same operations as described above conversely. Start from point 4 and insert the
filter carefully so that the corresponding electrodes, i.e. that of the filters and that of the wooden structure, are fit-
ted together.
26
FOR AUTHORISED STAFF ONLY)
2
®
ENGLISH