Setup Utility
Power Saving Configuration
The
Power
Saving
configurable only if your computer supports the power
management feature.
The following screen shows the Power Saving Configuration
parameters and their default settings:
Power Management Mode ..................................... [Enabled ]
Power Saving Operation Mode .......................... [QuickStart]
IDE Hard Disk Standby Timer ...................... [ 15] Minute(s)
Monitor Power Saving Timer ........................ [ 15] Minute(s)
System Standby Timer ................................ [Off] Minute(s)
System Suspend Timer ............................... [Off] Minute(s)
Monitored Activities
IRQ 2/IRQ 9 ............ [Disabled]
IRQ 3 ...................... [Disabled]
IRQ 4 ...................... [Disabled]
IRQ 5 ...................... [Disabled]
IRQ 7 ...................... [Disabled]
QuickStart State Timer........................................ [ 2] Second(s)
Point Device Location ......................................... [PS/2]
= Move Highlight Bar,
PgDn/PgUp = Move Screen, F1 = Help, Esc = Exit
Power Management Mode
This parameter allows you to reduce power consumption.
When this parameter is set to
IDE hard disk and system timers.
deactivates the power management feature and all the
timers.
48
Configuration
Power Saving Configuration
IRQ 8................... [Disabled]
IRQ 10................. [Disabled]
IRQ 11................. [Disabled]
IRQ 12................. [Enabled ]
IRQ 15................. [Enabled ]
= Change Setting
, you can configure the
Enabled
parameters
are
Page 1/1
Setting to
Disabled
User's Guide