Storage - Intex PureSpa Greywood Deluxe SB-HWF20 Owner's Manual

MAINTENANCE (continued)
Spa Surround
Barefoot areas and relaxing areas around the spa shall be cleaned on a regular basis. No cleaning water may
fl ow into the spa or spa water cycle. The dirt and cleaning agents shall be rinsed carefully to drain in the spa
surround.
Spa Tub and Cover Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
• Clean and dry the area to be repaired thoroughly.
• Remove the patch backing paper and press patch fi rmly over the puncture. Smooth out the surface to
remove any air bubbles under the patch.
In regions subject to freezing temperatures, drain, clean, disassemble and properly store the spa set and related
components indoors when the temperature drops below 4°C (39°F).
1. Drain and clean the spa following the "Spa Tub Drainage" and "Spa Tub Cleaning" sections.
2. Reverse set up instructions to defl ate and disassemble the spa tub, spa control unit and spa cover air
bladder.
3. To defl ate the tub and the cover air bladder:
a) Open the defl ation outlet cap (27) with the included bolt
wrench (6) (see drawing 19).
b) Insert defl ation hose adaptor (28) into the defl ation outlet.
c) Insert infl ation hose (7) over the defl ation hose adaptor (28).
d) Insert the other end of the infl ation hose into the tub air valve
or cover air bladder valve.
e) Press the air bubble
f) When defl ation is completed reverse above steps and
ensures the defl ation outlet cap (27) is securely fastened.
Caution: Only use for the purpose described in this manual.
Keep the infl ation hose away from water or small objects when the
defl ation function is activated to avoid damage to the blower motor.
4. Make sure all the spa components and accessories are thoroughly
clean and dry before storage. Air-dry the spa tub in the sun for an
hour before folding.
5. Fold the spa tub loosely and avoid any sharp corners to prevent
damage or leakage to the spa tub liner.
6. Prepare additional new cartridges for next time use.
7. Store the spa tub and accessories indoors, in a dry, temperature controlled, between 0º – 40ºC
(32º – 104ºF), storage location.
8. The original packing can be used for storage.
S AVE THESE INSTRUCTIONS

STORAGE

button to defl ate.
(352IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 09/18/2020
27
6
28
352
English
A
19
1
2
3
7
Page 26