Operation - Intex PureSpa Greywood Deluxe SB-HWF20 Owner's Manual

SPA CONTROL PANEL
C
D
E
On/Off Button: Once the unit is plugged in, press this button to active the control panel
buttons. Press this button again to turn off all currently activated functions.
Lock/Unlock Button: Press and hold this button 3 seconds to lock/unlock the control buttons.
If you forget to lock the keypad controls, the system will automatically lock it after 1 minute of
inactivity. The icon on the display is green when locked.
Control Panel Battery Indicator: The battery indicator will turn green when it is fully charged;
turn red when it requires charging and fl ashing red when it is in charging mode.
Bubble Button: Use this button to activate the massage system, which has a 30-minute
auto-shutoff feature. The bubble icon on the displays is green when activated.
CAUTION: Do not run Bubble system when the cover is attached, air can
accumulate inside the spa and cause irreparable damage and bodily harm.
Water Filter Button: This button turns the fi lter pump on and off . The water fi lter icon on the
display is green when activated and fl ashing 002H which is the minimum preset operating
hours. Press again to increase the preset time from 002H, 004H to 006H. Pressing the button
after the maximum number of hours (006H) will turn off the fi lter pump and the LED display
shows the spa water temperature. If you have selected too many hours keep pressing to repeat
the cycle. Once the operating time is set, the LED display will stop fl ashing after 10 seconds
and the fi lter pump starts working. The cycle repeats itself at the same time each day for the
number hours selected.
If the heating system is activated it will override the fi lter pump preset time function.
To view the preset time while the fi lter pump is operating, press
briefl y fl ash the preset hours for 10 seconds and then display back the remaining operating
hours. To adjust the preset time, press
previous steps.
Adjustment Buttons: Press the increase or decrease buttons to adjust the desired function
settings. Press and hold the button will rapidly increase or decrease the numbers.
LED Display: Once plugged in the LED displays the current water temperature automatically.
If the control panel (5) is activated and away from the control base charging dock, the LED
display will go blank after 5 minutes. Press any button to resume the control panel.
Always check the control panel battery indicator. Recharge the control panel after each use.
NEVER use the spa if indicated water temperature is more than 40°C (104ºF).
S AVE THESE INSTRUCTIONS
(352IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 09/18/2020

OPERATION

A: On/Off Button
B
B: Lock/Unlock Button
A
C Control Panel Battery Indicator
F
D: Bubble Button
E: Water Filter Button
G
F: Increase Button
G: Decrease Button
H
H: LED Display
button twice until the display is fl ashing and repeat
WARNING
English
button, the display will
Page 15
352
A