Table of Contents
Advertisement
3.
Connect neutral wire
Connect neutral wire (blue) of power supply cord to the right
terminal screw of the terminal block. Tighten screw.
4.
Connect ground wire
Connect ground wire to the center terminal. Tighten screw.
5.
Connect active wire
Connect active wire (brown) to the left terminal. Tighten screw
and strain relief screws.
Finally, reinsert tab of terminal block cover into slot of dryer
rear panel. Secure cover with hold-down screw. Now, go to
Venting Requirements.
Direct Wire Connection
3.
Prepare your 3-wire cable for
direct connection
Direct wire cable must have 5 ft. (1.52 m) of extra length so
dryer may be moved if needed.
Strip 3
/
" (89 mm) of outer covering from end of cable. Strip
1
2
insulation back 1" (25 mm). If using 3-wire cable with ground
wire, cut bare wire even with outer covering. Shape wire ends
into hooks.
4.
Connect wires to terminal block
To connect wires to terminal block, place hooked end of wire
under terminal block screw, facing to the right, squeeze
hooked end together and tighten screw.
5.
Connect neutral wire
Place hooked end of neutral wire (blue) of power supply
cable under the right screw of terminal block (hook facing
right). Squeeze hooked end together. Tighten screw.
17
Advertisement
Table of Contents
