Advertisement
The receiver can be paired with eight different transmitters (remote but-
tons). Pairing with more buttons will remove the first entries made.
Unpairing
To clear the list of transmitters cooperating with the receiver, press the PROG button and hold it
down for at least 10 seconds. Fast flashing of communication LED will indicate that the memory
of the controller has been cleared.
Local buttons
Short press of a button activates the roller-blind in the selected direction of movement. Sub-
sequent press during the roller-blind movement causes it to stop.
Long press of a button (for longer than 5 seconds) activates the programming mode of the
passage time of the roller-blind.
Passage time programming
The default time of roller-blind passage is 30 seconds.
To change this time you need to:
unroll the roller blind to the maximum by pressing the down direction button;
when the roller-blind stops, release the down direction button and then press and hold the
up direction button of the roller-blind;
after 5 seconds the roller-blind will start to roll up, and when it stops in the utmost upper
position immediately release the up direction button;
time of the roller-blind passage can be adjusted in the range of 5÷120 seconds.
Remote buttons
The FW-RC4, FW-RC10 transmitters operate on the principle of a bistable switch: one
press of a button activates the roller-blind in a selected direction of movement, the
second press of a button during the movement of the roller-blind causes it to stop.
The FW-RC5 transmitter also has separate inputs ON (always raise the roller-blind) and
OFF (always lower the roller-blind).
- 5 -
Advertisement
