Specifications; Safety Cautions - AHA Chamfer-Pro User Manual

Specifications

Chamfer-Pro
Maximum beveling
Width (B)*
Maximum beveling
Thickness (45°) (A)*
beveling Angle
V-Block Length
Number of Inserts
Weight
Motor Specifications
* (A), (B)  Page 8

Safety Cautions

1. This machine is not waterproof. Work in damp condition may cause injuries or damages
to machines. Electrical safety cautions should be kept at all times.
2. When connecting the power cord, be sure to set the switch at "OFF" position.
(Connect the power in accordance with the local electrical installation regulations.)
3. Check if there's enough space for work before working.
4. When the machine is at operation, do not leave the work area and pay attention to
the machine, and do not stand or walk underneath the machine.
5. Be sure to wear safety goggles and ear protection kits at work.
6. Keep your hands away from the Cutter(List No. 6) when connected.
7. Do not operate the machine nearby inflammable materials since hot particles scattering
may cause fire.
8. Connect the electric source in accordance with local electricity regulations.
9. At the time of first trial work of new materials, be sure to set the beveling thickness at
the minimum level and increase the thickness gradually.
10. Start the work after turning on the motor. After the work is finished, separate the
machine away from the material processed and then turn off the motor.
11. Upon completion of one piece of work, remove the chip or dust from the equipment
by air blowing or etc.
Chamfer-Pro User's Manual
Chamfer-Pro User's Manual
Single Phase 230V(or 115V), 50/60HZ, 2200W
 CP1000
 CP2100
CP 1000
10 mm
7 mm
0° ~ 60°
224 mm
6 EA
11.3 Kg
- 3 -
CP 2100
21 mm
15 mm
0° ~ 60°
224 mm
12 EA
11.5 Kg
AHA Industrial Co / www.ahaind.com