Usage Of Roller Plate - AHA Chamfer-Pro User Manual

Usage of Roller Plate

1. Purpose
When you do the beveling work, you need to
do the work by sticking the Big Plate of the V-
Block (List No. 30) to the workpieces. However,
the surfaces of the workpieces may not be
smooth enough to do the beveling work
because of bad surface smoothness, rusts and
dirt. In these cases, the friction between the V-
Block Plate and workpieces become very big,
thereby making it difficult to do the beveling
work. This optional item, Roller Plate, enables
easier and faster beveling work by decreasing
the friction.
2. The differences between standard V-Block Plate and Roller Plate
The total length of standard V-Block Plate is 224mm. When you chamfer both edges of
workpieces, it is needed that minimum 112mm of the workpieces should be contacted to
the V-Block Plate. In the meantime, the total length of the Roller Plate is 264mm and it is
needed that minimum 264mm of the workpieces should be contacted to the V-Block
Plate.
3. Other aspects of Roller Plate
In order to achieve even beveling results on both edges of the workpieces, it is
recommended to install extension plates (approximately 140mm) on both edges of
workpieces to stabilize the Roller Plate, as illustrated below, thereby enabling even
beveling results and better workability.
[Starting point ]
Cutter position
Roller Plate
Chamfer-Pro User's Manual
beveling direction
- 13 -
[Ending point ]
Cutter position
Roller Plate
AHA Industrial Co / www.ahaind.com