How To Convert From Cp-2100 To Cp-1000 - AHA Chamfer-Pro User Manual

5. When you do the beveling work by laying down the pipes, disassemble the Large Plate
(List No. 30) and Small Plate (List No. 28) from the End Cap (List No. 26) and change the
positions and assemble them again. After that, install the Roller Guide (List No. 31-33) on
the Large Plate (List No. 30) and do the beveling work. When you do the beveling work by
laying down the pipes, you should set the intended beveling angles by setting the same
degrees on the scale of the machine. That is to say, if you want 30 degrees beveling, set
the scale at 30 degrees.
6. To secure the stability of the beveling work, if needed, you can put another Roller Guide
(List No. 31-33) on the groove of the right-hand side of the Large Plate of the V-Block (List
No. 30).
7. As per the size of the diameters of the pipes, you can install the Roller Guides either on
the left side only or on both sides. The positions of the Roller Guides could be either
inside or outside of the pipes, as per the sizes of the diameters.
8. When you start the beveling work, do the test beveling first, which means that start with
shallow beveling and then increase it to the intended beveling depth.
9. In order to prevent damages of the insert tips, always approach the machine slowly to the
workpiece in the beginning.

How to convert from CP-2100 to CP-1000

1. Purpose
When you would like to chamfer thin steel plates, (less than 7mm thick) it is
recommended to convert from CP-2100 to CP-1000 to save working time since CP-1000
requires only 6 inserts, while CP-2100 requires 12 inserts.
2. Difference of CP-1000 and CP-2100
The difference of CP-1000 and CP-2100 is the difference of number of cutter heads.
CP1000 has one cutter head while CP2100 has two cutter heads.
Other specifications like motor performance and frames are the same for both CPs.
3. How to convert
In order to convert from CP-2100 to CP-1000, loosen the bolt (List No. 13) and remove
frame (List No. 21) and List No. 12, 11 and 6 parts in sequence. After that, assemble Shim
(List No. 7-1) first and then reassemble List No. 6, 7-2, 11, 12 and 21 parts in sequence
and tighten the bolt (List No. 13).
Chamfer-Pro User's Manual - 11 - AHA Industrial Co / www.ahaind.com