LG LRG4111ST Service Manual page 23

REMOVING THE CONVECTION FAN BLADE AND FAN MOTOR
1. Turn off the electrical supply and gas supply
going to the range and remove the oven racks.
2. Remove the 9 Fan cover screws and remove Fan
cover.
3. Remove 5 screws from the burner assembly and
then remove the burner cover U.
< burner cover U >
4. Remove 2 screws from the burner assembly and
then Remove the stabilizer.
< Stabilizer >
COMPONENT ACCESS
3 screws 3 screws
3 screws 3 screws 3 screws 3 screws 3 screws 3 screws 9 screws 3 screws 3 screws 3 screws 3 screws 3 screws 3 screws 3 screws 3 screws 3 screws
5. To remove the fan blade :
- Remove the nut by
screwing clockwise. The
fan blade can be replaced
from inside oven.
• Be careful not to bend the fan blade
- Doing so can result in vibration, noise, and
poor performance of convection when
operating.
6. To remove the fan motor assembly :
a) Pull the range out of its mounting location so
that you can access the rear of the unit.
b) Remove the rear panel from the unit (See step
3~4 on page 3-2 for procedure).
c) Disconnect the wire connection and remove
the 3 screws.
4 screws 4 screws 4 screws 4 screws 4 screws
4 screws 4 screws 3 screws 4 screws 4 screws 4 screws
4 screws 4 screws 4 screws 4 screws
4 screws 4 screws 4 screws
3-10
Nut Nut Nut
Nut Nut Nut Nut
Nut Nut Nut Nut
Nut Nut
Nut Nut Nut Nut Nut Nut
Nut Nut
Nut Nut Nut Nut
Nut Nut Nut Nut Nut
CAUTION
Wire connection Wire connection Wire connection Wire connection Wire connection
Wire connection Wire connection
Wire connection Wire connection Wire connection Wire connection Wire connection Wire connection
Wire connection Wire connection Wire connection Wire connection Wire connection