LG LRG4111ST Service Manual page 22

REMOVING THE BROIL BURNER ASSEMBLY
WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electric shock.
• Make sure the igniter connector is
completely outside when reinstalling
the broil burner assembly.
CAUTION
• Use caution when handling sheet
metal parts while servicing the
range.
- Some parts may have sharp edges, which
could result in injury.
1. Turn off the electrical supply and gas supply
going to the range.
2. Remove the oven door and remove the racks
from inside the oven.
3. To remove the broil Burner assembly:
a) Remove the back cover by removing the
screw.
b) Remove the 3 screws in the order for easily
removing.
Screw (2ea)
COMPONENT ACCESS
Screw + Washer
c) Remove the igniter connector in the cavity
(To get the connector, remove 1 screw of wire
supporter and pull the wire toward the cavity.).
d) Remove the broil burner assembly.
NOTE : When removing the screws, make sure
holding the Broil burner assembly.
4. To remove the igniter:
a) Perform step 1-3 on this page.
b) Remove the 2 screws and then remove the
igniter.
3-9
2 screws 2 screws 2 screws 2 screws 2 screws
2 screws 2 screws 2 screws 2 screws 2 screws 2 screws
2 screws 2 screws 2 screws 2 screws
2 screws 2 screws 2 screws