Assembling And Disassembling The Cutting Set; Changing The Cutting Set - ADE FL-E Series Operating Manual

Assembling and disassembling the cutting set

Unplug the power cord from the mains outlet before assembling the cutting set.
Use utmost care when assembling and disassembling the blade. It can cause cuts on
the hands!
To assemble the cutting system, proceed as follows:
1. Insert the worm housing firmly into the housing and tighten it with the handle (lever or knob,
depending on the model).
2. Insert the worm into the worm housing. At the same time, check the fitting in the guide of the
worm housing.
3. For models FL-E-1200 + FL-E2200: Insert the pre-cutter into the worm with the flat side facing
outwards. Insert the pre-cutter only if the notch on the pre-cutter matches the guide on the
worm housing.
4. Insert the cross blade in the worm with the hub facing outwards / with the cutting edge facing
the pre-cutter.
5. Install the perforated disc. Insert the perforated disc only if the notch on the perforated disc
matches the guide on the worm housing.
6. Put on the union nut and tighten. The union nut must exert a slight pressure on the perforated
disc, and the perforated disc must exert a slight pressure on the blade. The union nut must
NEVER be firmly tightened, as this can cause rapid wear of the blade and the perforated disc.
7. Insert the filler neck into the filling tray.
To disassemble the cutting system, proceed in reverse order.

Changing the cutting set

A versatile use is ensured by the fact that you can use perforated discs with different hole diameters
depending on the desired granulation.
In any case, the union nut is the last part to put on.
It is important to ensure that the order of assembly of the cutting set be followed as
described above.
9 FL-E-200626-Rev007-UM-en