TEFAL Element BJ750D Instructions For Use Manual page 20

2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE
AWAY FROM WATER SPLASHES AND ANY SOURCES OF HEAT.
• Kettle is only to be used with the stand provided.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If
the kettle is too full, boiling water may spill out.
• Do not use without water.
• Check that the lid without tea filter is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS
SOCKET.
• Tea maker is now in standby mode. Signal indicator lights will flash
with 2 beep sounds.
5. TO START THE KETTLE
A. Boiling water
– Press the on/off button to directly start boiling water.
maker color signal light will light up in RED with a beep sound.
– As soon as the required temperature is reached, tea maker will
automatically switch off, then the color signal light will be off with
2 beep sounds.
B. 70°C – 90°C water heating and tea brewing
– Press the select button repeatedly to set the desired temperature
from options: 70°C, 80°C, 85°C or 90°C. The corresponding
temperature indicator light will light up.
– Press the on/off button to start heating water with selected
temperature
sound.
– When the selected temperature is reached, tea maker will
automatically switch off, then color signal light will be off with 2
beep sounds.
– To start tea brewing, you can fill the desired amount of tea leaves
or tea bag into tea filter.
twist clockwise to lock the tea filter with the lid.
– Close the lid with tea filter to start brewing.
C. 70°C – 90°C keep warm heating
– To start keep warm heating cycle, press select button repeatedly to
set the desired temperature
20
(fig. 5)
7.2), then color signal light will be on with a beep
(fig
(fig 8)
(fig 7.1).
(fig 7.1)
Hold the handle and remove the lid;
(fig 10)
(fig 4)
Tea
(fig 6)
(fig 9)