Installation - ATEN VS-162 User Manual

Installation

Make sure that power to all the devices you will be
1.
connecting up has been turned off.
Make sure that all devices you will be connecting up
2.
are properly grounded.
Single Stage
Refer to the installation diagram on the next page (the numbers
in the diagram correspond to the numbers of the steps) and do
the following:
1. Use a male to male DVI cable to connect your computer's
DVI port to the VS-162 / VS-164's Video In port.
2. Use a male to male audio cable to connect your computer's
speaker port to the VS-162 / VS-164's Audio In port.
3. Plug your DVI monitors and speakers into the Media Out
ports.
Note: Since Port 1 is the port that supports DDC2B, you
must start with Port 1. After that, you can use any
available port.
4. Plug the power adapter that came with your switch into an
AC power source, then plug the power adapter cable into the
switch's Power Jack.
2005-03-02
- 7 -