ATEN CS-1742 User Manual page 13

The rear panel components are described in the table below:
1.
Power Jack If you choose to use external power, the power adapter
cable plugs into this jack.
Note: Use of a power adapter (DC 5V) is optional, and
requires a separate purchase. See p. 10 for power
adapter details.
2.
Firmware The Firmware Upgrade Cable that transfers the firmware
Upgrade Port upgrade data from the administrator's computer to the
CS-1742 / CS-1744 plugs into this RJ-11 connector.
See p. 23 for firmware upgrading details.
3.
Console Port The cables from your console components (keyboard,
Section mouse, monitors, speakers and microphone), plug in
here. Each port is marked with an icon to indicate itself.
4.
CPU Port The cables that link the switch to your computers plug in
Section here.* Each CPU port is comprised of two connectors:
The upper connector carries the audio data (microphone
and speakers) and the video data for monitor B; the
lower connector carries the USB data (keyboard, mouse,
and peripherals) and the video data for monitor A.
5. USB Port Cables from your USB peripherals (printers, scanners,
etc.) can plug in here, as well as into the USB port on the
front panel.
* Only cables specifically designed to work with this switch can be used (see
the Cables section on p. 3, for details). Do NOT attempt to use ordinary 15
pin VGA connector cables to link these ports to the computers.
Introduction
2004-09-24
7