Samsung AM0 TNZDCH Series Installation Manual page 35

Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and follow the directions
below.
1. Press the and
2. Press the / button to select
3. Press the / button to select
Option No.: 02XXXX-1XXXXX-2XXXXX-3XXXXX
or Press the /
Option No.: 05XXXX-1XXXXX-2XXXXX-3XXXXX
• The first digit represents the page number and the remaining five digits are installation option.
NOTE • The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
4. Press the / button to set the installation option code in order. Press
5. Press the button to save and complete the option setting.
6. Press the button to exit to normal mode.
• Press
• Option code will not be applied if you don't press
NOTE
• Setting Installation option code is available only with a master wired remote controller.
• Setting Installation option code is available when there is one on one connection between a wired
remote controller and an indoor unit.
AM072TNZDCH_IM_DVM V-AHU_AA_EN_.indd 35
buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
and then press
and then press
button to select and then press
button anytime during setup to exit without setting.
button to enter a Sub-menu setting screen.
button to enter a Indoor unit installation option code setting screen.
button to enter a Sub-menu setting screen.
button to go to the next page.
button.
English 35
2020-02-14 오전 10:33:40