Samsung AM0 TNZDCH Series Installation Manual page 34

Setting an indoor unit address and installation option
Set the indoor unit address and installation option with remote controller option. Set the each option separately since you
cannot set the ADDRESS setting and indoor unit installation setting option at the same time. You need to set twice when
setting indoor unit address and installation option.
Setting an indoor unit address
1. Press the and
2. Press the / button to select
3. Press the / button to select and then press
Data bit
1 2 34 56
• The Main/RMC Address which is currently setting will flicker.
NOTE • Data bit 1 and 2 present Indoor unit main address checking.
• Data bit 3 and 4 present Indoor unit main address setting(outdoor unit reset is needed to set).
4. Press the / button to set the Indoor unit Main/RMC Address.
5. Press the button to save and complete the option setting.
6. Press the button to exit to normal mode.
• Press the
• Address will not be applied if you don't press
NOTE
• Setting Main/RMC Address of an Indoor unit is available only with a master wired remote
controller.
34 English
AM072TNZDCH_IM_DVM V-AHU_AA_EN_.indd 34
buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
and then press
button to enter a Indoor unit option code setting screen.
button to save and complete the option setting.
button to enter a Sub-menu setting screen.
button.
2020-02-14 오전 10:33:39