Ergotron DS100 Series Installation Manual

Horizontal dual monitor desk stand

Hide thumbs Also See for DS100 Series:

Download this manual

DS100 Series

Horizontal Dual Monitor

Desk Stand

Ergotron USA 1-800-383-1916

Ergotron Europe +31 20 312.29.39

Rev B. 11/04

INSTALLATION MANUAL

1 of 6

M4 x 10 mm

#8-32

75-100mm

1/2"

(13mm)

M4 x 10 mm

3/32"

1/2"

(13mm)

888-33-092-01

Need help?

Do you have a question about the DS100 Series and is the answer not in the manual?

Page 1 INSTALLATION MANUAL DS100 Series Horizontal Dual Monitor Desk Stand Ergotron USA 1-800-383-1916 Ergotron Europe +31 20 312.29.39 M4 x 10 mm M4 x 10 mm #8-32 3/32" 75-100mm 1/2" 1/2" (13mm) (13mm) Rev B. 11/04 1 of 6 888-33-092-01...
Page 2 1/8" 20"-22" Ergonomics (508-559mm) Ergonomía Ergonomie Ergonomi 25" (635mm) 888-99-014 888-33-092-01 2 of 6 Rev B. 11/04...
Page 3 If your monitor uses a screw size other than M4 x 10mm, DO NOT use the M4 x 10mm screws or knob provided as they could result in damage to the monitor. 75mm Monitor Mount M4 x 10 mm M4 x 10 mm 100mm Monitor Mount 8-32 3/32"...
Page 4 20"-22" (508-559mm) 25" (635mm) CAUTION When adjusting Desk Stand height, make sure monitors are properly supported to prevent them from sliding down too quickly. 888-33-092-01 4 of 6 Rev B. 11/04...
Page 5 OVERVIEW After completion of installation steps, evaluate pivot function for your speciﬁ c installation. Ergotron’s pivot joints are factory set to provide the proper pivot control and moving force for the majority of users. If excessive force is required to adjust your setup, or if your monitor does not remain in the desired position, pivot adjustment may be required.
Page 6: Troubleshooting
Ergotron Europe +31 20 312.29.39 Patents Pending and Patented U.S. & Foreign. Ergotron is a registered trademark of Ergotron, Inc. Reproduction of this material in whole or part for any purpose other than 1181 Trapp Road • St. Paul, MN 55121 that authorized by Ergotron, Inc.