Advertisement
4
Install the fixed rail assemblies
If you are installing your server using slide rails, go to task 7
If you do not have enough space around your rack to open the front and back doors
completely, remove the doors before starting this task to allow adequate access.
If you are installing your server into a tapped-hole rack, follow the instructions in the IBM Systems
Hardware Information Center, then return to task 10
details about how to access the information center, see task 12
Locate the rack-mounting hardware kit, the cable-management arm, and the fixed
4.1
rail assemblies that were included with your server.
Determine where in the rack to place the server. Remove any filler panels
4.2
necessary to allow adequate access to the location where you will install your
server.
Note:
in the lower part of the rack.
Install units into the lower part of the rack first. Place larger and heavier units
Install the slide rail assemblies.
Cable the HMC and the server
Finish your system setup.
in this guide. For
Advertisement
