Advertisement
3
Prepare the rack for installation
If you are installing your server into a new rack, ensure that you have completed the
3.1
unpacking instructions that were provided with the rack.
If your server is already installed into a rack, skip to task 10
server
.
3.2
Place the rack in the location of the installation.
Use the wrench that was provided with your rack to level the rack by raising or
3.3
lowering the front and back leveling feet .
3.4
Install the stabilizer bracket
Tip:
If necessary, remove any trim kit pieces that were previously installed on the
rack. Removing the trim kit pieces allows you to read the EIA units on the rack.
A
B
on the front of the rack.
Cable the HMC and the
A
B
Advertisement
