Phil & Teds LATCH BASE Instructions Manual page 31

6 7
6 • Check the level indicator to make sure it is level. If it
is not level, remove vehicle belt and adjust the foot on
the LATCH base then re-install base. Check that the
ball rests in the zone of your child's weight. Refer to
the Adjusting the Recline section of this instruction.
7 • To remove the infant car seat from the LATCH base,
pull up the red release handle located on the LATCH
base. Lift infant car seat away from the LATCH base.
• To remove LATCH base from vehicle, open lock-off
8
and unbuckle the belt.
Instructions