Advertisement
Instructions
3
5
4
3
• Push down on the foot end of LATCH base and pull the
free end of the lap belt to tighten LATCH base against the
vehicle seat. CHECK to make sure LATCH base is secure
by holding both sides of the LATCH base near the lap belt
and moving it from side to side and front and back. The
lap belt should not loosen and the LATCH base should
not move easily. The LATCH base should not move more
than 1 inch (2.5 cm) from side to side or front to back.
4
• Close the lock off over the lap belt until it clicks
into places.
5
• Attach the infant car seat into the LATCH base until you
hear a click. Lift up on the handle of the infant car seat to
make sure that it is securely attached in the LATCH base.
If the infant car seat does not latch securely into the
LATCH base, CHECK to make sure green is visible on
the indicators before installing the infant car seat onto the
LATCH base. If green is NOT visible pull up on red release
handle. ALWAYS lift up on the infant car seat to check that
it is securely attached to LATCH base.
Advertisement
