Advertisement
Instructions
1
BEFORE installing LATCH
base, make sure vehicle
is on level ground. Place
LATCH base on an
approved LATCH vehicle
seating location.
2
Base Installation with LATCH
Check that the LATCH INFANT CAR SEAT SYSTEM
has been installed correctly.
1
• Remove LATCH strap from LATCH storage
compartment and extend the strap to its longest
length (see step 8 of this installation section). Lay
the anchor strap between the 2 guide lines (shown
in red). Route the LATCH belt through the belt path
openings on both sides of LATCH base and under the
belt lock-off. Make sure not to twist the belt and make
sure it lies flat.
• Clip the LATCH connectors onto the lower vehicle
2
seat anchors on both sides of the LATCH base.
CHECK to make sure they are attached by pulling
on them.
Advertisement
