Advertisement
Instructions
6
8
7
• Check the level indicator to make sure it is level. If it is
6
not level, remove LATCH connectors and adjust the foot
on the base then re-install LATCH base. Check that the
ball rests in the zone of your child's weight. Refer to the
Adjusting the Recline section of this instruction.
7
• To remove the infant car seat from the LATCH base,
pull up the red release handle located on the LATCH
base. Lift infant car seat away from the LATCH base.
8
• To remove LATCH, open lock-off, push button on
adjuster to loosen LATCH then unhook from the anchor
point.
Repeat steps as shown on the other side of the LATCH
base.
Store LATCH strap in the storage compartment.
Advertisement
