Conventional Ethernet Link Led Is Not Illuminated - Keysight APM0100E User Manual

Conventional Ethernet Link LED is not Illuminated

The 100BASE-T1/Ethernet Media Converter has not established a link to the
connected Ethernet device. Try the following:
– Double-check the Ethernet connections on the 100BASE-T1/Ethernet Media
– Ensure that the Ethernet port on the device is enabled and active
– Remove and reconnect the Ethernet cable
– Try a different Ethernet port, if possible
– Try a different Ethernet cable
– Disable and then re-enable the Ethernet port within Windows on the PC
If the supplied Ethernet cable that came with the 100BASE-T1/Ethernet Media
Converter does not work, but a different Ethernet cable does, contact Keysight
"Service and Support"
Keysight APM0100E 100BASE-T1/Ethernet Media Converter User Guide
Converter and Ethernet device
on page 34.
Troubleshooting 3
27