Table of Contents
Advertisement
– Rx (Green): Flashes when receiving data by the 100BASE-T1/Ethernet Media
– Tx (Green): Flashes each time when transmitting data by the 100BASE-T1/
Under normal circumstances, you will see the Link LED always on, with the Rx and
Tx LEDs flashing at different rates depending on how much data is being sent by
each device connected to the 100BASE-T1/Ethernet Media Converter. Assuming
that all devices are functioning correctly, the Err LED should rarely, if ever, light
up.
BroadR-Reach (100BASE-T1) Connector Pinout
Refer to
Molex Mini50 jacks, with the pin numbers shown in
Table 2-1
Pin Number
1
2
3
4
Pins are numbered 1 to 4 from left to right looking at the jack shown in
Figure 2-4
Keysight APM0100E 100BASE-T1/Ethernet Media Converter User Guide
Converter from the connected Automotive Ethernet device.
Ethernet Media Converter to the attached Automotive Ethernet device.
Table 2-1
for the pinout of the 100BASE-T1/Ethernet Media Converter's
100BASE-T1/Ethernet Media Converter Data BroadR-Reach
(100BASE-T1) Molex Mini50 Jack Pinout
Label
No Connect
TRD+
TRD-
No Connect
100BASE-T1/Ethernet Media Converter BroadR-Reach
(100BASE-T1) Molex Mini50 Jack with Pin Numbers
Description
–
Data transmit and receive, positive
Data transmit and receive, negative
–
Introduction
Figure
2-4.
Figure
2
2-4.
17
Advertisement
Table of Contents
