Inserting An Sd Card (Dome Camera) - Balter IP-D1231VR Manual

Zoom: Loosen the upper screw with a screwdriver.
Take care not to remove it completely.
Focus: Loosen the lower screw using a screwdri-
ver. Take care not to remove it completely.
After adjusting zoom and focus, mount the inner cover and casing.
2.1.6 Inserting an SD card (Dome Kamera)
-Disconnect the camera from the power supply before removing or inserting an SD card.
-Be careful when inserting or removing the SD card, otherwise it might be damaged. If you have trouble inserting the
SD card properly, make sure to insert it exactly as depicted below
-Don't remove or insert SD cards when it rains or during high humidity.
-The camera's dome should not be taken off for more than 5 minutes to avoid condesation.
The camera supports microSD cards up to 128GB
Insert the microSD card with the contacts downwards.
To remove an SD card from the camera, push it inwards until it is ejected.
Move the component by dragging the screw to the left or
right until the desired zoom level is reached.
Verify the settings via a monitor or smartphone.
Move the component by dragging the screw to the left or
right until the image is focussed correctly.
Verify the settings via a monitor or smartphone.
8