Alarm; Motion Detection; Adjusting The Motion Detection - Balter IP-D1231VR Manual

8.4 Alarm

8.4.1 Motion Detection

Activate
Sensititvity
Activate recording
Afteralarm recording
Alarm output
Activation time
Send email
Empty
All
8.4.1.1 Adjust the motion detection
By standard, the whole image is selected for motion detection.
If you want to active motion detection only for certain areas of the image, use the
mouse.
The areas marked red are selected for motion detection.
Activate/Deactivate motion detection
Adjust sensitivity in 7 levels
Activate recordings onto an SD card
Recording time after a movement
Activate Alarm Output if a motion is detected
Activation time of the alarm output
Send email if a motion is detected
Empty marked areas
Select the whole image
57